Warning: Hypotonic and hemolytic.

Do not inject until made approximately isotonic by addition of appropriate solute.

Pharmacy Bulk Package

Not For Direct Infusion

Sterile Water for Injection USP is a clear, colorless, odorless liquid. It is sterile, hypotonic, nonpyrogenic, and contains no bacteriostatic or antimicrobial agents. Sterile Water for Injection USP is a diluent suitable for intravascular injection after first having been made approximately isotonic by the addition of suitable solute.

pH: 5.5 (5.0-7.0)

Not made with natural rubber latex, PVC or DEHP.

The plastic container is made from a multilayered film specifically developed for parenteral drugs. It contains no plasticizers and exhibits virtually no leachables. The solution contact layer is a rubberized copolymer of ethylene and propylene. The container is nontoxic and biologically inert. The container-solution unit is a closed system and is not dependent upon entry of external air during use. The container is overwrapped to provide protection from the physical environment and to provide an additional moisture barrier when necessary.

Sterile Water for Injection USP is used as a diluent for other parenteral drugs. As such, Sterile Water for Injection USP contributes to the water for hydration when provided in parenteral drug and fluid therapy, after the introduction of suitable additives and/or mixture with suitable solutes to approximate isotonicity.

Sterile Water for Injection USP is indicated for use in adults and pediatric patients as a diluent in the aseptic preparation of parenteral solutions or as a vehicle for drug administration after admixture or dilution.

None known.

This solution is for compounding only, not for direct infusion.

Hypotonic and hemolytic. Do not inject until made approximately isotonic by addition of an appropriate solute, due to the possibility of hemolysis.

The administration of intravenous solutions can cause fluid and/or solute overload resulting in dilution of serum electrolyte concentrations, overhydration, congested states or pulmonary edema. The risk of dilutional states is inversely proportional to the electrolyte concentration.

WARNING: This product contains aluminum that may be toxic. Aluminum may reach toxic levels with prolonged parenteral administration if kidney function is impaired. Premature neonates are particularly at risk because their kidneys are immature, and they require large amounts of calcium and phosphate solutions, which contain aluminum.

Research indicates that patients with impaired kidney function, including premature neonates, who receive parenteral levels of aluminum at greater than 4 to 5 mcg/kg/day accumulate aluminum at levels associated with central nervous system and bone toxicity. Tissue loading may occur at even lower rates of administration.

Refer to the package insert of the solute used.

Reactions which may occur because of the solution or the technique of administration include febrile response, infection at the site of injection, venous thrombosis or phlebitis extending from the site of injection, extravasation and hypervolemia.

The physician should also be alert to the possibility of adverse reactions to drug additives. Prescribing information for drug additives to be administered in this manner should be consulted.

If an adverse reaction does occur, discontinue the infusion, evaluate the patient, institute appropriate therapeutic countermeasures and save the remainder of the fluid for examination if deemed necessary.

Overdosage (hypotonic expansion) is a function of an increase in fluid intake over fluid output, and occurs when the increase in the volume of body fluids is due to water alone. Overdosage may occur in patients who receive large quantities of electrolyte-free water to replace abnormal excessive fluid losses, in patients whose renal tolerance to water loads is exceeded, or in patients who retain water postoperatively in response to stress.

Manifestations of water intoxication are behavioral changes (confusion, apathy, disorientation and attendant hyponatremia), central nervous system disturbances (weakness, muscle twitching, headaches, nausea, vomiting, convulsions) and weight gain.

Treatment consists of withholding fluids until excessive water is excreted. In severe hyponatremia it may be necessary to cautiously administer hypertonic saline to increase extracellular osmotic pressure and excretion of excess water by the kidneys.

This solution is for intravenous use only after admixture or dilution. Do not inject until made approximately isotonic by addition of appropriate solute.

Following suitable admixture of prescribed drugs, the dosage is usually dependent upon the age, weight and clinical condition of the patient as well as laboratory determinations. See directions accompanying drugs.

The dosage and administration of Sterile Water for Injection USP is dependent upon the recommended dosage and administration of the solute used. Fluid administration should be based on calculated maintenance or replacement fluid requirements for each patient.

Some additives may be incompatible. Consult with pharmacist. When performing admixture or dilution, use aseptic techniques. Mix thoroughly. Do not store.

Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit.

Sterile Water for Injection USP is supplied in 2000 and 3000 mL Pharmacy Bulk Package containers packaged 4 per case.

Rx only

Revised: May 2019

Warning: Hypotonic and hemolytic. Do not inject until made approximately isotonic by addition of appropriate solute.

Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration and final infusate should be inspected for cloudiness or precipitation immediately after mixing, prior to administration, and periodically during administration, whenever solution and container permit. Use of a final filter is recommended during administration of all parenteral solutions where possible.

Sterile Water for Injection USP in the Pharmacy Bulk Package is intended for use in the preparation of sterile, intravenous admixtures. Additives may be incompatible with the fluid withdrawn from this container. Complete information is not available. Those additives known to be incompatible should not be used. Consult with pharmacist, if available.

When compounding admixtures, use aseptic technique. Mix thoroughly.

Do not store any unused portion of Sterile Water for Injection USP.

Preparation

• Inspect overwrap and primary bag.
• Do not use if overwrap has been damaged.
• Do not use unless solution is clear and closure is intact.

1.  To open: Tear overwrap starting from the tear notches. (Figure 1)

For Pharmacy Bulk Packages

• The Pharmacy Bulk Package is to be used only in a suitable work area such as a laminar air flow hood (or an equivalent clean air compounding area).
• For compounding only. Do not use for direct infusion.
  
  
  
• Do not use/penetrate blocked port (see Figure 2, left upper corner).
  
  
  
• Suspend container.
• Remove aluminum foil of set port at the bottom of container (see Figure 3).
  
  
  
• Attach suitable transfer device or compounding set (Figure 2). Refer to complete directions accompanying device.
• Hang bag on suitable fixture (Figure 4).
  
  
  
• Once container closure has been penetrated, withdrawal of content should be completed within 4 hours.

Important Admixing Instructions

• The contents are intended for use in a pharmacy admixture program and are restricted to the preparation of admixtures for infusion or, through a sterile transfer device, for the filling of empty sterile syringes.
• Additives may be incompatible with the fluid withdrawn from this container. Consult with pharmacist, if available. When compounding admixtures, use aseptic technique, mix thoroughly and do not store.
• Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever solution container permits. (See PRECAUTIONS, General).

B. Braun Medical Inc.

Bethlehem, PA 18018-3524 USA

1-800-227-2862

www.bbraun.com

Made in USA

Y36-002-998  LD-454-2

STERILE WATER FOR

INJECTION USP

WARNING: HYPOTONIC AND HEMOLYTIC.

DO NOT INJECT UNTIL MADE

APPROXIMATELY ISOTONIC BY ADDITION OF

APPROPRIATE SOLUTE.

REF S8505

NDC 0264-7385-50

LOT

EXP.

2000 mL

Pharmacy Bulk Package

Not For Direct Infusion

No antimicrobial agent or other substance has been added.

Sterile. Pharmacy bulk package container.

WARNINGS: Some additives may be incompatible.

Consult with pharmacist. When introducing additives,

use aseptic techniques. Mix thoroughly. Do not store.

CONTAINS NO MORE THAN 25 mcg/L OF ALUMINUM

Recommended Storage: Room temperature (25°C). Avoid

excessive heat. Protect from freezing. Do not remove overwrap

until ready for use. Once container closure has been

penetrated, withdrawal of content should be completed

within 4 hours. See Package Insert.

Not made with natural rubber latex, PVC or DEHP. 

Rx only

Y38-000-065     LD-455-3

B. Braun Medical Inc.

Bethlehem, PA 18018-3524 USA

1-800-227-2862

SET

Sterile Water Injection 2L Container Label

STERILE WATER

FOR INJECTION USP

WARNING: HYPOTONIC AND HEMOLYTIC.

DO NOT INJECT UNTIL MADE

APPROXIMATELY ISOTONIC BY ADDITION OF

APPROPRIATE SOLUTE.

REF S8506

NDC 0264-7385-60

LOT

EXP.

3000 mL

Pharmacy Bulk Package

Not For Direct Infusion

No antimicrobial agent or other substance has been added.

Sterile. Pharmacy bulk package container.

WARNINGS: Some additives may be incompatible.

Consult with pharmacist. When introducing additives,

use aseptic techniques. Mix thoroughly. Do not store.

CONTAINS NO MORE THAN 25 mcg/L OF ALUMINUM

Recommended Storage: Room temperature (25°C).

Avoid excessive heat. Protect from freezing. Do not

remove overwrap until ready for use. Once container

closure has been penetrated, withdrawal of

content should be completed within 4 hours.

See Package Insert.

Not made with natural rubber latex, PVC or DEHP. 

Rx only

Y38-000-066     LD-456-3

B. Braun Medical Inc.

Bethlehem, PA 18018-3524 USA

1-800-227-2862

SET